REPORT

2015 summer semester team B 4thJune 10, 2015

620

Weekly report from team B. We continued to work on the tailplane and the vertical tail during the class. We managed to complete their basic structures and also installed gussets in applicable places. What we should now work on was the wing, but our draft design for the wing was not yet at the point of being suitable to be cut out by the laser cutter. Consequently, we decided to leave the work on the wing for later. We did put films on the tail components, and cut out the center ribs for the wing (with the laser cutter) outside of class time, so we hope to start working on the wing next week.
Science 1, College of Arts and Sciences
Go Yasui
授業中は尾翼周りの作業を進めました。垂直尾翼・水平尾翼ともに骨組みを完成させ、補強のためガセットを入れました。次に取り掛かるべきは主翼ですが、図面がまだレーザーカッターで切り出せる状態ではなく、また、授業中にレーザーカッターが故障したため、それ以後の作業は授業後に行うことにしました。授業外の時間で尾翼に膜を張り、センターリブを切り出したので、来週からは主翼の製作に移ります。

教養学部前期課程理科一類
安井 豪

|